For the complete documentation index, see llms.txt. This page is also available as Markdown.

Visualising in Configure mode

View relative level, relative priority and line of sight directly in the viewport in Configure mode.

In Configure mode, you can visualise relative level, relative priority and line of sight directly in the viewport. Relative level and relative priority show how the settings of the zones assigned to a Coverage Beam or LF Coverage Beam affect the beam, so you can adjust them before or after optimizing. Line of sight shows which areas are obstructed from the current selection.

Viewing Relative Level and Priority in Configure mode

These controls are only available in Configure mode.

Turning on a view

The Relative Level and Relative Priority controls are floating icons at the top of the viewport. Neither view is turned on automatically.

  1. Switch to configure mode.

  2. Select the Coverage Beam or LF Coverage Beam you want to view.

  3. Select Relative Level or Relative Priority at the top of the viewport.

Only one of these views can be on at a time. Turning on one view turns off the other.

Relative Level

The Relative Level view shows the relative level pattern across the zones assigned to the beam. The relative level combines SPL and the zone's level into a single value. It isn't frequency specific, so the pattern applies to all frequencies.

Relative level is shown as a colour gradient in dB. The scale is fixed and runs from 0 dB to -16 dB.

This view is most useful before you optimize a beam so that you can check the level pattern across your zones and adjust each zone's Relative Level in the Assign Zones to Beam Panel. You can also turn on the view after a beam has been optimized.

Zones set to Avoid aren't included in the gradient and are shown in the default zone colour.

Relative Priority

The Relative Priority view shows each zone's Relative Priority setting on the viewport, so you can see the priority of every zone at a glance instead of checking each slider.

Priority is shown on the same logarithmic scale as the slider, from 0.01 to 100, with 1 as the default. For more information, see Assigning zones to a Coverage Beam.

Changing the number of segments

The priority legend is divided into segments, and each zone is coloured by the segment its priority falls into. To change the number of segments:

  1. Select the settings button next to the legend.

  2. Choose the number of segments. The default is 4, and you can choose from 2 to 20.

Use fewer segments for a simple overview and more segments to see smaller differences in priority between zones.

Line of sight preview

The Line of sight preview shows which areas are obstructed from the current selection. It works for audience zones and boundary zones, and doesn't require Acoustic Shadowing to be on.

  1. Switch to configure mode.

  2. Select the entity you want to preview.

  3. Select Line of sight preview (the eye icon) in the toolbar at the top of the viewport.

Obstructed areas are shown in brown, and areas that are visible keep their normal default colour. A legend next to the colour bar explains the obstruction colour.

Was this helpful?